Maintenance
Transmission
154
BA RC50_RC70 en 00
Switch off diesel engine and remove ignition key.
Fasten filling hose to the valve [1] and fill the tyre till it reaches the
specified air pressure ("Technical data", page 170).
4.06.07 Changing the tyres
WARNING
Heavy weight!
Serious injuries or death caused by crushing or getting caught during
assembly.
■
Perform installation work on firm ground (flat, stable, horizontal).
■
Carry out fitting work only when the engine is stopped.
■
Use suitable load suspension and hitching gear with an adequate
loading capacity.
■
Do not step underneath suspended loads.
WARNING
Tipping over the machine!
Serious injuries or death through the machine tipping over sideways
because of a shift in the center of gravity.
■
On one axle, only mount and use tyres that are the same type and
have the same design, profile and diameter.
■
Always adjust the tyre pressures on one axle to the same value.
NOTICE
Increased material wear!
Material damage through increased wear on tyres, running gear and
drive parts as a result of a combination of different tyres on each axle.
■
On one axle, only mount and use tyres that are the same type and
have the same design, profile and diameter.
■
Always adjust the tyre pressures on one axle to the same value.
Preparation
To Next Page
Loading...
Need help?
General
