Wacker Neuson RC50 User Manual

Auxiliary equipment
Padfoot shells
218
BA RC50_RC70 en 00
Place both scrapers [1] for the padfoot drum on the front crossbeam
facing opposite directions.
Screw the nut [2] onto the stud and tighten it.
Tightening the bolts on the hose clamp mounting
1
1
2
Tighten the hexagon nut [1] of the hose clamp [2].
Perform this work on the left and right-hand hose clamp mountings.
6.06.05 Maintenance
NOTE
The instructions itemized in the "Important information about
maintenance work" must always be followed during all
maintenance work.
Maintenance overview
For the first time after 10 operating hours
10 h
Tighten the padfoot shell screwed connections
Every 100 operating hours
100 h
Tighten the padfoot shell screwed connections
Technical data
RC50
Designation Value Unit
Weight of shell half 240 kg
Weight of front crossbeam with scraper 140 kg
Weight of rear scraper 50 kg
RC70
Designation Value Unit
Weight of shell half 330 kg
Weight of front crossbeam with scraper 220 kg

Wacker Neuson RC50 Specifications

General

Brand	Wacker Neuson
Model	RC50
Category	Trash Compactor
Language	English