Auxiliary equipment
Dozer blade
BA RC50_RC70 en 00
199
6.05.04 Maintenance
NOTE
The instructions itemized in the "Important information about
maintenance work" must always be followed during all
maintenance work.
" Only lubricants with this symbol are permitted ("Technical data",
page 160 onwards).
Basic maintenance work
Remove dirt deposits from the dozer blade.
Check that the screwed connections on the console are tight.
Replace the wearing edge in good time in order to prevent damage to
the body of the blade.
Maintenance overview
Every 250 operating hours
Lubricating the bearings
Lubricating the lifting cylinder bolts
Switch off the diesel engine and remove the ignition key.
Grease lubricating nipple [1] (2 each).
To Next Page
Loading...
Need help?
General
