Operation
Loading and transporting
60
BA RC50_RC70 en 00
Crane loading
Special instructions
■
Park the crane vehicle on flat ground with the necessary load-bearing
capacity. Comply with all applicable safety regulations when doing so.
■
The crane's load table must correspond to the weight and to the
centre of gravity of the machine to be lifted.
NOTE
If the weight of the machine is unknown, set the maximum
operating weight (see type plate).
■
Take suitable precautions to block access to the lifting area in order to
prevent any persons from entering the danger zone.
■
Attach lifting tackle to the lifting lugs provided.
■
Note the load-bearing capacity of the lifting tackle.
■
Use lifting frames or spreader beams if necessary.
To Next Page
Loading...
Need help?
General
