Operation
Starting the machine
BA RC50_RC70 en 00
87
NOTE
The starter is only connected to the start switch when the drive
lever is in position P. This is the only way to start the diesel
engine.
Conditions for starting the engine:
■
The drive lever [1] is engaged in the position P. Indicator light [2] on.
■
The EMERGENCY STOP button [3] is released.
■
The on-board power supply and electrical system are switched on:
The ignition key [5] is in position I.
■
The gearshift [4] is set to the transportation gear or working gear.
■
The cold start assistance indicator light is off.
Turn the ignition key [5] to position III and hold it there until the diesel
engine starts.
a
Diesel engine starts.
a
Ignition key turns back to position I after releasing.
To Next Page
Loading...
Need help?
General
