WAGNER EPG-Sprint X Operating Manual

56
EPG-SPRINT X
P_01759
EPG
SPRINT X
0
%
10
20
30
40
50
Ø
12
10
11
9
8
m /h
2.0
3.0
0.5
0.3
0.1
1.5
3
5.5
4.5
3.5
2.5
80
100
%
Tri
90
60
70
18
17
34
35
15
OPERATING MANUAL
VERSION 06/2014 ORDER NUMBER DOC2329371
7.8.4 PROCEDURE FOR CLEANING PURGING WITH AUTOMATIC GUNS
Procedure:
1. End coating operation.
2. Remove powder suction unit (suction lance, powder injector) from powder tank.
3. Switch on purge function by pressing "Purge" button 17 on the control unit.
LED display 18 starts to  ash and indicates readiness for purging.
4. Process should be repeated for each spray gun that is to be purged.
If you do not want a purging process, press "Standby" button 15.
5. Start purge process using "Gun Start" on unit's control.
6. Stop purge process using "Gun Stop" on unit's control.
7. Re-activate control units in standby mode by pressing the "Standby" button 15.
8. Press "Purge" button 17 to return to normal coating mode.
The LED display 18 no longer  ashes.
9. Once the suction lance has been lowered into the powder tank, the coating operation
can be continued again.
Note:
If con guration parameter C16 is set to "ON", the purge function can only be activated via
the serial interface.

WAGNER EPG-Sprint X Specifications

General

Brand	WAGNER
Model	EPG-Sprint X
Category	Control Unit
Language	English