41
PEA-C4XL-S
OPERATING MANUAL
VERSION 03/2014 ORDER NUMBER DOC2345334
Before replacing the spray gun, any powder residue must be thoroughly removed.
The wearing parts in the spray gun, marked in the spare parts list with " ", must be regularly
checked and, if necessary replaced.
Procedure:
1. Switch o the high-voltage generation on the control unit, close the compressed air
supply and relieve the system of pressure.
2. Press locking button 1 and carefully remove the gun from supporting tube 2.
3. Disconnect electrical cable 3 from connection I on the spray gun.
4. Disconnect the powder feed hose 4 from connection G on the spray gun.
The handling of the hose coupling is described in Chapter 6.5.
5. Disconnect the atomizing air hose 5 from connection K on the spray gun.
6. Detach the grounding cable 6 from grounding screw L on the spray gun.
7. Connect electrical cable 3 to connection I on the new spray gun.
8. Connect the powder feed hose 4 to connection G on the spray gun.
9. Connect the atomizing air hose 5 to connection K on the spray gun.
10. Connect the grounding cable 6 from grounding screw L to the spray gun.
11. Carefully insert the spray gun into supporting tube 2 until the locking button 1 locks
into place in the drilled hole in supporting tube 2.
12. Switch on the high-voltage and open the compressed air supply.
13. The spray gun is ready for use again.
To Next Page
Loading...
Need help?
General
