890362_b•en•21.03.2011 We reserve the right to carry out improvements
13
4.3 Manual operation
In addition to the installed safety and comfort functions, you can also operate
all sun shading products at the Quatronic dialog by hand.
If, after this, a comfort function such as the sun control becomes active, you
can always intervene by hand.
Exception:
In the case of safety functions (e.g. wind alarm), manual operation is blocked
for the duration of the alarm.
NOTE Your manual move commands are not stored, which means that the sun
shading product does not return to the position you adjusted manually after a
comfort function (e.g. sun control) becomes active.
Manual operation is performed using the
/
arrow buttons on the corre-
sponding facade. The display then changes to Position and Cause.
The cause is displayed as ManOp. See also Chapter 5.1.3 on page 20.
4.3.1 Awnings, pleated blinds,
roller shutters
Example Lowering the sun shading products on facade 4:
Briefly press the
button on the far right under the display (facade 4).
Facade: 1 2 3 4
Wind: 8m/s 8m/s 8m/s 8m/s
Time: 10:26:47 Wednesday, 20.11.2008
The Position and Cause menu is displayed.
Position: Upper Upper Lower
Cause: Rain Wind Sun ManOp
The
symbolises the movement. The "Manual" cause flashes for the duration
of the set run time.
At the end of the run time, the display changes as follows:
Position: Upper Upper Lower Lower
Cause: Rain Wind Sun ManOp
Briefly press the
button above the display to raise the product again.
Position: Upper Upper Lower
Cause: Rain Wind Sun ManOp
Basics
To Next Page
Loading...
Need help?
General
