WAREMA Quatronic dialog - Display Mode

890362_b•en•21.03.2011
We reserve the right to carry out improvements
22
WAREMA Quatronic dialog
®
Operating instructions
5.1.7 Display mode
In the Displ menu, you can specify whether the displays of the Quatronic
dialog should change every 4 seconds, or if they should only change when
the disp/prog button is pressed.
 Keep the disp/prog button pressed for approx. 5 seconds.
Wind: 8m/s 8m/s 8m/s 8m/s
Time: 10:26:47 Wednesday, 20.11.2008
 The selection menu is displayed:
Select the Wind RunT Timer Sun
settings: Rain Temp Product -->
 Press the  button under --> to open the second page of the selection
menu.
Select the Displ Ice ComfT Time
settings: Passw Da/Du Rel.H. -->
 Press the  button above the word Displ.
 The Display switching mode menu is displayed.
Display switching mode:
1. By pressing button "disp/prog"
 Press the  or  arrow button to change the display mode.
 The currently selected mode is displayed in each case.
Display switching mode:
2. Automatically every 4 seconds.
 Leave the menu after completing the entries using the disp/prog button.
 This saves the changes you made.
Menus
Display menus