890362_b•en•21.03.2011 We reserve the right to carry out improvements
23
5.2 Selection menus
When you change to the selection menus, you enter the programming mode.
Here you can adjust the behaviour of the control unit to your requirements. A
detailed description of the functions and parameters can be found here:
Safety functions Chapter 6 on page 26
Comfort functions Chapter 7 on page 37
General parameters Chapter 8 on page 57
CAUTION
Do not make changes to the safety settings that may result in damage to
your sun shading products.
The safety functions of the Quatronic dialog protect the controlled sun shad-
ing products against damage due to the weather conditions. All parameters
were set correctly during commissioning.
Keep the disp/prog button pressed for approx. 5 seconds.
Wind: 8m/s 8m/s 8m/s 8m/s
Time: 10:26:47 Wednesday, 20.11.2008
The selection menu is displayed:
Select the Wind RunT Timer Sun
settings: Rain Temp Product -->
Press the
button under --> to open the second page of the selection
menu.
Select the Displ Ice ComfT Time
settings: Passw Da/Du Rel.H. -->
Press the
button under --> again to return to the first page of the selection
menu.
In the selection menu, you can now use the
/
arrow buttons to open the
individual parameter menus for wind, sun, etc.
NOTE Use the disp/prog button to return to the display menus. This saves the
changes you made.
Menus
Selection menus
To Next Page
Loading...
Need help?
General
