WAREMA Quatronic dialog - Time Switch Control

890362_b•en•21.03.2011 We reserve the right to carry out improvements
51
7.5 Time switch control
The time switch control of the Quatronic dialog lets you raise your sun shad-
ing products at a certain time (e.g. at dawn) and lower them at another time
(e.g. at dusk). Separately for Monday to Friday and for the weekends, you
can set 1 switch time for lowering the products and 1 switch time for raising
the products.
The time switch control only triggers UP/DOWN move commands.
NOTE Time switch control is deactivated by default.
When the time set under MoFr
 or SaSu  is reached, the sun shading prod-
ucts move up. The "timer UP phase” is then active.
The following display appears:
Position: Lower  Upper 
Cause: ManOp Clock Rain Clock
When the time set under MoFr  or SaSu  is reached, the sun shading prod-
ucts move down. The "timer DOWN phase” is then active.
The following display appears:
Position: Lower  Upper 
Cause: ManOp Clock Rain Clock
NOTE If the time switch control is switched on (e.g. after the wind, ice or rain moni-
tor is switched off), the sun shading products are lowered during the "timer
DOWN phase".
Comfort functions
Time switch control