WAREMA Quatronic dialog - External Venetian Blinds; Stopping a Movement

890362_b•en•21.03.2011
We reserve the right to carry out improvements
14
WAREMA Quatronic dialog
®
Operating instructions
4.3.2 External venetian blinds
Closing the slats
 Press the
 button briefly.
Position: Upper Upper Lower 
Cause: Rain Wind Sun ManOp
Opening the slats
 Press the  button briefly.
Position: Upper Upper Lower 
Cause: Rain Wind Sun ManOp
Lowering the sun shading products to the lower limit position
 Press the
 button for approx. 2seconds.
Position: Upper Upper Lower 
Cause: Rain Wind Sun ManOp
 After the DOWN run time elapses, the slats are adjusted to the preselected
slat angle (see Chapter 8.2 on page 59).
Raising the sun shading products to the upper limit position
 Press the
 button for approx. 2seconds.
Position: Upper Upper Lower 
Cause: Rain Wind Sun ManOp
4.3.3 Stopping a movement
During a downward movement
 Press the
 button briefly.
Position: Upper Upper Lower 
Cause: Rain Wind Sun ManOp
During an upward movement
 Press the
 button briefly.
Position: Upper Upper Lower 
Cause: Rain Wind Sun ManOp
Basics