890362_b•en•21.03.2011
We reserve the right to carry out improvements
44
WAREMA Quatronic dialog
®
Operating instructions
Select the desired parameter by pressing the
or
button.
Example Dawn/dusk Dawn
In this menu, you can change the settings for each facade (F1 - F4) using the
/
buttons.
Dawn limit UP
: 30Lx OFF OFF OFF
(Dawn) CH1 CH2 CH3 CH4
The OFF setting is achieved by setting the value to 0. The word OFF appears
instead of 0. This switches off the dawn/dusk control at the respective fa-
cade.
Leave the menu after completing the entries using the disp/prog button.
This saves the changes you made.
7.2.2 Dusk, dawn
The effects of the settings are addressed below in more detail.
The Dusk, Dawn limit values can be set to between 0 and 99 Lux.
Dusk: If the readings drop below the Dusk limit value, the sun shading prod-
ucts are lowered.
Dawn: If the readings exceed the Dawn limit value, the sun shading products
are raised
NOTE The brightness measured at photo sensor 1 is critical for the dawn/dusk con-
trol.
For the dawn/dusk control, the delays are fixed and cannot be individually
adjusted:
Dusk delay: 5 minutes
Dawn delay: 5 minutes
Comfort functions
Dawn/Dusk control
To Next Page
Loading...
Need help?
General
