890362_b•en•21.03.2011
We reserve the right to carry out improvements
50
WAREMA Quatronic dialog
®
Operating instructions
Select the Displ Ice ComfT Time
settings: Passw Da/Du Rel.H. -->
Press the
button below the word Rel.H.
The Rel. Humidity menu is displayed:
Rel. Humidity Lim.
Alloc
control settings:Lim.
Select the desired parameter by pressing the
or
button.
Example UP limit value Lim.
In this menu, you can change the settings for each facade (F1 - F4) using the
/
buttons.
Rel. humidity OFF OFF OFF OFF
Limit UP
: CH1 CH2 CH3 CH4
The OFF setting is achieved by setting the value to 0%. The word OFF appears
instead of 0%. This switches off the humidity control at the respective facade.
Leave the menu after completing the entries using the disp/prog button.
This saves the changes you made.
7.4.2 UP/DOWN limit value,
allocation
The effects of the settings are addressed below in more detail.
If the relative humidity reading exceeds the DOWN limit value, the sun shad-
ing product moves to the lower limit position.
If the relative humidity reading drops below the UP limit value, the sun shad-
ing product moves to the upper limit position.
Up to 4 humidity sensors can be connected to the Quatronic dialog. These
sensors are allocated to the 4 facades in the Alloc menu.
Comfort functions
Humidity control
To Next Page
Loading...
Need help?
General
