Wascomat Clarus Control SU620 - Page 138

138
Programme unit
DRAIN TIME WHEN OVERFILL 0:05
OIL LUBRICATION HOURS 100
PULSE TIME OIL LUBR. SEC 0:01
AMOUNTOFI/OMODULES(1-3) 3
DELAY CLEAR DOOR TEXT 04:00
MAX DRAIN TIME 4:00
TIMEOUT DURING PAUSE 1:00
MINIMUM TEMPERATURE INCREASE 5°C
DOOR OPEN DELAY FOR MOTOR LOST 1:00
ERROR, NO WATER Y
ERROR, OPEN DOOR Y
ERROR, DOOR LOCK Y
ERROR, LOW TEMPERATURE Y
ERROR, HIGH TEMPERATURE Y
1 2 3
4 5 6
7 8 9
0
OIL LUBRICATION HOURS 100
PULSE TIME OIL LUBR. SEC 0:01
AMOUNTOFI/OMODULES(1-3) 3
DELAY CLEAR DOOR TEXT 04:00
TIMEOUT DRAIN AT PROGRAM START 4:00
TIMEOUT DURING PAUSE 1:00
MINIMUM TEMPERATURE INCREASE 5°C
DOOR OPEN DELAY FOR MOTOR LOST 1:00
ERROR, NO WATER Y
ERROR, OPEN DOOR Y
ERROR, DOOR LOCK Y
ERROR, LOW TEMPERATURE Y
ERROR, HIGH TEMPERATURE Y
ERROR, WATER IN MACHINE Y
1 2 3
4 5 6
7 8 9
0
Timeout drain at program start
If water in machine at wash program start, and
level not lower than emty level within given value,
an error will be indicated.
Delay clear door text
Here you determine how long the text ”WAITING
FOR DOOR TO UNLOCK” will remain visible if, for
some reason, the door is not unlocked at the right
time.
When a wash program has ended, the text above
will be displayed until the door is unlocked. The
door is normally unlocked within one minute on
most machines.
If the door is not unlocked within a reasonable
time, the most common cause is probably jam-
ming in the lock mechanism. In these cases, the
text above may mislead the user, causing him to
think that the normal unlocking sequence is not
yet finished.
Use the numeric keys to
enter the value.
If you make a mistake while
entering digits:
Press ERASE.
When you have finished:
Press .
Use the numeric keys to
enter the value.
If you make a mistake while
entering digits:
Press ERASE.
When you have finished:
Press .