Wascomat Clarus Control SU620 - Drain Time

132
Programme unit
TEMPERATURESTEPINCOOL-DOWN 4°C
DEFAULT LOW EXTRACT TIME 00:10
DEFAULT MEDIUM EXTRACT TIME 00:15
DEFAULT HIGH EXTRACT TIME 00:20
DEFAULT DRAIN TIME 00:40
DEFAULT DISTR. TIME 00:30
DO UNBALANCE MEASUREMENT Y
DRAIN OPEN DELAY 0:13
START EXTRACT TIME 00:30
ROLLOUT TIME 00:01
PAY PER WASH ALARM 0
LOCK TEST DELAY 0:10
DRAIN TIME WHEN OVERFILL 0:05
OIL LUBRICATION HOURS 100
1 2 3
4 5 6
7 8 9
0
DEFAULT LOW EXTRACT TIME 00:10
DEFAULT MEDIUM EXTRACT TIME 00:15
DEFAULT HIGH EXTRACT TIME 00:20
DEFAULT DRAIN TIME 00:40
DEFAULT DISTR. TIME 00:30
DO UNBALANCE MEASUREMENT Y
DRAIN OPEN DELAY 0:13
START EXTRACT TIME 00:30
ROLLOUT TIME 00:01
PAY PER WASH ALARM 0
LOCK TEST DELAY 0:10
DRAIN TIME WHEN OVERFILL 0:05
OIL LUBRICATION HOURS 100
PULSE TIME OIL LUBR. SEC 0:01
1 2 3
4 5 6
7 8 9
0
2
1
Speed
Time
Drain open
Drain closed
Drain open delay
Here you determine whether you want a delay be-
fore the drain valve opens, for example if you want
the drum to have time to gather speed first, before
the valve opens.
The drain module
may be structured according to point 1 (here)
only, according to point 2 only, or a combi-
nation of 1 and 2, according to the way you
program.
1 Drain time
The drain will be open. The motor may be at a
standstill, on gentle action or normal action.
2 Distribution time
The drain will be open. The motor runs at dist-
ribution speed. During this time the wash load
will be distributed evenly around the walls of
the inner drum.
You can program this time here
Start extract time (i.e. Initial extraction time)
Here you determine the length of time for initial
extraction (if used).
When you are programming the ”main data” for
a wash program you can determine whether the
program is to begin with initial extraction. Ini-
tial extraction is used to spin the load outwards
against the drum walls, which makes it absorb
water more readily on first filling. As a result of this
the machine will not require so much extra filling
(repeated topping up) later (to maintain its required
water level).
There are two other functions affecting initial
extraction which can be programmed under SET-
TINGS 2:
• STARTEXTRACTSPEED
• STARTEXTRACTACCELERATION
Use the numeric keys to
enter the value.
If you make a mistake while
entering digits:
Press ERASE.
When you have finished:
Press .
Use the numeric keys to
enter the value.
If you make a mistake while
entering digits:
Press ERASE.
When you have finished:
Press .