Wascomat Clarus Control SU620 - Page 131

131
Programme unit
PAUSE TEST LEVEL 0
PAUSETESTTEMPERATURE -18°C
DEFAULT TEMPERATURE HYSTERIS 4 °C
TEMPERATURESTEPINCOOL-DOWN 4°C
DEFAULT LOW EXTRACT TIME 00:00
DEFAULT MEDIUM EXTRACT TIME 00:00
DEFAULT HIGH EXTRACT TIME 00:00
DEFAULT DRAIN TIME 00:00
DEFAULT DISTR. TIME 00:00
DO UNBALANCE MEASUREMENT N
DRAIN OPEN DELAY 0:13
START EXTRACT TIME 00:30
ROLLOUT TIME 00:01
PAY PER WASH ALARM 0
1 2 3
4 5 6
7 8 9
0
DEFAULT TEMPERATURE HYSTERIS 4°C
TEMPERATURESTEPINCOOL-DOWN 4°C
DEFAULT LOW EXTRACT TIME 00:00
DEFAULT MEDIUM EXTRACT TIME 00:00
DEFAULT HIGH EXTRACT TIME 00:00
DEFAULT DRAIN TIME 00:00
DEFAULT DISTR. TIME 00:00
DO UNBALANCE MEASUREMENT N
DRAIN OPEN DELAY 0:13
START EXTRACT TIME 00:30
ROLLOUT TIME 00:01
PAY PER WASH ALARM 0
LOCK TEST DELAY 0:10
DRAIN TIME WHEN OVERFILL 0:05
Y/N
Default values for re-start after unbalance
Here you determine the drain time and distribu-
tion time the machine will use if it cannot find the
time parameters it requires, e.g. during manual
operation of the drain in a washer extractor with a
suspended drum.
Unbalance measurement
Here you determine whether the machine will cal-
culate unbalance before it accelerates to extraction
speed. Drum unbalance can only be calculated in
washer extractors with suspended drums. It uses
torque data from the motor control unit to deter-
mine whether the imbalance is too high.
For washer extractors with suspended drums wit-
hout frequence control and which have a separate
unbalance switch, the answer to this question
should be No.
If you answer Yes (Y):
The machine will calculate unbalance before
every extraction sequence.
If you answer No (N):
The machine will not calculate unbalance.
Use the numeric keys to
enter the value.
If you make a mistake while
entering digits:
Press ERASE.
When you have finished:
Press .
Answer Yes (Y) or No (N).
Press .