Wascomat Clarus Control SU620 - Page 176

176
Motor and motor control
Assembly
1. Fit the new motor without locking the mounting bolts.
2. Fit the drive belt and adjust the belt tension with the tensioner on one
sideofthemotor.SesectionAdjustments-Drivebelttensionforde-
tails.
3. Connect the new motor to the motor control and use straps to secure
the cable.
4. Connect the motor cable to the motor.
5. Fit the lower rear piece and secure the drain hose connection with
screws.
6. Fit the upper rear piece.
7. Connect the voltage supply and verify that the motor operates normally.