Webdyn WebdynSunPM - Page 108

108
USER MANUAL – WebdynSunPM
Version 2.05
préliminaire
NTP server 1
NTP_Server1
address for the NTP 1 server used
to synchronise the concentrator
clock.
NTP server 2
NTP_Server2
NTP 2 server address used to
synchronise the concentrator clock
if server 1 did not respond.
If the NTP1 and NTP2 server values are left blank, the concentrator will not use NTP
synchronisation.
By default, the concentrator uses the free “pool.ntp.org” NTP server. This server
does not guarantee the exactness of the time synchronisation, nor its robustness.
The use of a specific NTP server is strongly recommended. Contact an NTP server
portal or supplier.
After having entered an NTP server, it can be tested by clicking one of the following buttons:
• “Set time from NTP”: launches NTP1 synchronisation and, if necessary NTP2
synchronisation and then applies it to the concentrator
• “Check NTP1”: Tests NTP1 server synchronisation without applying it to the
concentrator.
• “Check NTP2”: Tests NTP2 server synchronisation without applying it to the
concentrator.
A window opens to display the connection log: