Webdyn WebdynSunPM - Appendix A: _Config.ini File

160
USER MANUAL – WebdynSunPM
Version 2.05
préliminaire
Appendix A: “_config.ini” file
The authorised configuration parameters in the “<uid>_config.ini” file are the following:
Parameter
Description
Default value
BIN_Checksum
Indicates the firmware name to use to
update the gateway software. This
parameter cannot be empty if
BIN_FileName contains a value.
The firmware thus named must be in the
configured binary directory.
See the section on update configuration for
how to use updates. (3.1.2.1)
BIN_FileName
Indicates the checksum for the firmware
indicated in the BIN_FileName field.
This parameter cannot be empty if
BIN_Checksum contains a value.
See the section on update configuration for
how to use updates. (3.1.2.1)
Concentrator_Identifier
Gateway identifier (uid)
If this field is left empty, the default
identifier is used.
WPMABCDEF (where ABCDEF
are the last characters of the
serial number).
FTP_DirAlarm
FTP 1 server directory in which the alarms
from the concentrator are stored.
Note that the directory MUST exist. The
concentrator will not create it when
uploading files.
/ALARM
FTP_DirBin
FTP 1 server directory in which the
concentrator will get the update files when
requested.
See the section on update configuration for
how to use updates. (3.1.2.1)
/BIN
FTP_DirCert
FTP 1 server directory in which the
concentrator will get the certificates to use
for MQTT connections.
See the MQTT configuration section for
more details.
/CERT
FTP_DirCmd
FTP 1 server directory in which the
concentrator will get the command files
used later.
/CMD