Syntax:
reboot
Parameters: none
3.3.5 “status” command
The “status” command returns current configuration information to the sender of the
command by text message.
The response is contained in 6 text messages.
Each text message has its number and the total number of text messages in the header.
The returned text messages are:
1/6
idSite=<Siteid>
fmwVersion=<firmware version>
• idSite: is the web site name, i.e. the concentrator identifier (uid)
• firmware version: the version of firmware currently loaded on the concentrator
2/6
eth0:
ip=<ipaddr>
mask=<mask>
gw=<gateway>
dns=<dns>
• ipaddr: IP address configured on the ethernet 1 interface
• mask: subnet mask configured on the ethernet 1 interface
• gateway: the gateway address used by the concentrator to connect to an external
network on the ethernet 1 interface
• dns: the list of DNS servers used to resolve names for the ethernet 1 interface If several
DNS servers are configured, they are delimited by the “/” character
3/6
eth1:
ip=<ipaddr>
mask=<mask>
gw=<gateway>
dns=<dns>
• ipaddr: IP address configured on the ethernet 2 interface
To Next Page
Loading...
