• port: the port server 1 is configured on
• last: the date and time the concentrator last connected to server 1 and the connection
result in the following format: “DD/MM HH :MM <connection result>”
6/6
srv=<server>
status=<status>
type=<type>
mode=<mode>
addr=<ipaddr>
port=<port>
last=
• server: configured server 2 name
• status: indicates whether server 2 is enabled or not. The possible values are:
o enabled: server 2 is enabled
o disabled: server 2 is disabled
• type: indicates the server type. The possible values are:
o ftp : server 2 is of the FTP type
o sftp: server 2 is of the SFTP type
o mqtt: server 2 is of the MQTT type
o mqtts: server 2 is of the MQTTS type
• mode: the server 2 running mode. The possible values are:
o strategy_wsun1_compliant_backup: the server is an FTP type server and is
configured as a backup server
o strategy_wsun1_compliant: the server is an FTP typoe server and is configured
as the main server
o strategy_wsun1_compliant_backup_secured: the server is an SFTP type server
and is configured as a backup server
o strategy_wsun1_compliant_secured: the server is an SFTP type server and is
configured as a backup server
• ipaddr: configured server 2 address
• port: the port server 2 is configured on
• last: the date nand time the concentrator last connected to server 2 and the
connection result in the following format: “DD/MM HH :MM <connection result>”
Syntax:
status
Parameters: None
3.3.6 SunSpec “detect” command
The “detect” command is used to launch a SunSpec scan on the modbus bus.
Syntax:
To Next Page
