上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD.
5 / 36
• Switch to Technician interface.
1.2.1.2 Tool Selecting and Machining Mode Display Area
This area consists of the following:
• Tool selecting area: used to select tools for machining.
See Select the Tool(s) for details.
• Machining mode display area: used to show current machining mode. See
Execute Automatic Machining for how to switch the machining mode.
1.2.1.3 Axis Direction and Mode Selecting Area
This area consists of the following:
• Axis direction buttons
Used to move each axis towards positive/negative direction:
– Press an axis direction button. The machine tool moves at jogging speed.
– Press Rapid and an axis direction at the same time. The machine tool
moves at rapid jogging speed.
– Press several axis direction buttons. The selected axes move at the same
time.
Note: The axis number controlled by axis direction buttons differs in the selected tool number.
• Mode buttons
Used to switch to the following modes:
– Jog: press an axis direction button. The machine tool keeps running until
you release the button.
– HW: the machine tool is controlled by the handwheel.
– Step: click an axis direction. The machine tool moves 0.01mm, 0.1mm,
1mm or customized step size.
The default customized step size is 5mm and the customized step should
not be too large to avoid damage due to misoperation.
Note: Please do not click the axis direction button too frequently because the system
needs a certain time to execute the command.
To Next Page
Loading...
Need help?
General
