1
WEILER E1650 REMIXING TRANSFER VEHICLE
5-18
Maintenance
5
Maintenance Procedures
Elevator Chain - Adjust Tension / Uneven Sag
1. With engine off and ignition key removed, adjust
chain until bottom of chain slat is 2” (51 mm) at
measurement position shown in detail view B, 5-16.
Adjust both sides of chain until chain sag is even from
side to side, +/- 1/4” (6 mm).
•To tighten chain, turn adjustment rod (1) CW.
•To loosen chain, turn adjustment rod (1) CCW.
2. Clean material off of cleanout door and sealing edges
to allow door to close tightly.
3. Start engine. Close and latch cleanout door. Verify
door is fully closed. Turn engine off.
Slip and fall hazard.
Adjust chain tension while standing on a securely placed ladder. Never
climb onto top of machine to access adjusters.
To Next Page
Loading...
