9 Servicing / Cleaning
Training manual Convotherm 4 129
3.
Check that the catch fastener lies in the OK range of the ad-
justment gauge for floor-standing units.
4.
If this is not the case, undo the two fixing screws on the door
catch unit and move the unit until the adjustment gauge lies in
the OK range.
5.
Re-tighten the fixing screws.
Adjusting the door gap on floor-standing units: Hinge side
1.
Close the appliance door.
2.
The door gap needs to be checked at the top and bottom of the
appliance on the hinge side.
To Next Page
Loading...
