Welbilt Convotherm 4 - Page 130

9 Servicing / Cleaning
Training manual Convotherm 4 130
3. To do this, place the adjustment gauge for floor-standing units
in the position shown in the illustration.
4.
Check that the door gap lies in the OK range of the adjustment
gauge for floor-standing units.
Adjusting the door gap on floor-standing units: Front section
1.
Close the appliance door.
2.
Place the adjustment gauge for floor-standing units in the posi-
tion shown in the illustration.
3.
Check that the door gap lies in the OK range of the adjustment
gauge for floor-standing units.
Safety thermostat reset for floor-standing units
1. Follow the safety thermostat reset procedure that was described for the adjustment gauge for table-top
units.