Welbilt Merrychef eikon e1s - Door Assembly and Seal Replacement

121
eikon e1s
Service and repair guide
Removing / fitting the door assembly and door seal
Requirements and tools
Check that the following requirements have been met:
• The appliance has been disconnected from the power supply and protective measures have been taken to ensure
the power cannot be switched on again.
• The appliance is cool.
• The high voltage capacitors are discharged before commencing work.
• Anti-static precautions have been taken.
Tools required:
• Two metal pins (length: 10 mm / 0.4 in)
• Stanley knife
• Sealant
• Cloth for wiping residue
Unassemble door
1.
Open the door fully and locate the holes positioned in the upper area of the
hinges.
2.
Push the two metal pins through the holes in each hinge.
3.
Close the door onto the two metal pins and then free the door by pulling
upward and forward. The door should now be fully removed.