Welbilt Merrychef eikon e1s - Page 123

123
eikon e1s
Service and repair guide
Refitting the door
1.
Keeping the removed door flat at 90 degrees to the oven, push the two
metal hinges inside the available slots at the bottom of the oven. You
should feel the hinges fitting in place.
2.
Close the appliance door. Re-open and close to check the fitting.
Note: If the door was removed to replace door seal, you can now leave the
door closed and let the sealant dry naturally for 24 hours or you can heat up
the oven to dry the seal.
Heating up the oven to dry the seal
3.
Switch the oven on and let it heat to 260 degrees.
4.
Keep the door shut for two hours.
The oven will be ready for usage again after 2 hours
• Never use the oven without the door seal attached properly.
• Never switch on the oven without the door attached and closed.