Welch Allyn Connex Spot Monitor - Copy a Configuration File; Download a Configuration File to Install on Another Device

5. Under Progress Summary, locate the section you want to edit (Clinical, Informatics,
IT, or Biomed) and click the specific step you want to edit.
6. Review the selections in each step and modify them as desired.
7. Click SAVE AND CONTINUE to accept the changes or BACK to return to the
previous screen without saving.
Clicking SAVE AND CONTINUE automatically moves you to the next step in that
section of the Progress Summary. When you reach the last step in a section,
cllicking SAVE AND CONTINUE returns you to the Progress Summary.
8. Repeat steps 5 through 7 until you complete all desired edits.
9. Click List Configurations on the navigation bar to see a new date stamp in the
Updated column for your configuration file.
Copy a configuration file
To copy a saved configuration file, complete the following steps:
1. Access the Configuration Tool at http://config.welchallyn.com.
2. Log in with a username and password.
3. Click List Configurations on the navigation bar.
4. Locate the configuration file to be copied in the list, and click the on the right
side of the table.
5. Either accept or enter a new name for the copied file in the Copy Configuration
dialog, then click Copy.
6. Observe your new configuration file on the List Configurations tab.
Download a configuration file to install on another device
To download a saved configuration file, complete the following steps:
From the Configuration Tool
1. Access the Configuration Tool at
http://config.welchallyn.com.
2. Log in with a username and password.
3. Click List Configurations on the navigation bar.
4. Locate the configuration file to be downloaded in the list, and click the on the
right side of the table.
The configuration file downloads to the tray on your PC.
5. Using the dropdown menu on the right side of the downloaded file, select Show in
folder.
Windows Explorer opens the Downloads folder with the most recent download
selected.
6. Copy the downloaded configuration file to a USB flash drive.
7. See "Install a configuration file" for instructions to load this configuration on another
device.
100
Device configuration and setup Connex
®
Spot Monitor