Welch Allyn Connex Spot Monitor - Specify Active Directory Settings; Ethernet Status

DNS IP address Enter the IP address of the DNS server.
3. Touch Apply.
4. Do one of the following:
• To continue in Advanced settings, touch another tab.
• To exit Advanced settings and return to the Home tab, touch Exit.
Specify Active Directory settings
Use the Active Directory settings to manage the device communication address and
access settings.
1. In Advanced settings, touch the Network > Active Directory tabs.
2. Select Enable Active Directory.
3. Specify settings.
Setting Action/Description
Domain name Enter the domain name.
Group Enter the domain name group.
User name Select the clinician ID type (user name, account name, or
employee ID.
Authentication user name Enter the user name.
Authentication password Enter the password.
4. Touch Test network connection.
The device displays the Active Directory test status.
5. Click OK.
6. Do one of the following:
• To continue in Advanced settings, touch another tab.
• To exit Advanced settings and return to the Home tab, touch Exit.
Service tab
Ethernet status
In Advanced settings, touch the Service > Ethernet status tabs. This Ethernet status
vertical tab displays read-only data about the Ethernet connection:
Network
• MAC address
• IP address
• Subnet mask
• Gateway
• DHCP server
• DHCP lease time
Network statistics
• Rx bytes
30
Advanced settings Connex
®
Spot Monitor