MS3
This section applies only to devices with a Classic (MS3) stand.
Remove the power supply from the MS3 stand
Before removing the power supply, power down the monitor, disconnect the power
cable from the monitor, and disconnect the power cord from the wall.
1. With one hand holding the power supply, remove the 2 Phillips screws inside the
basket that hold the power supply in place and put them aside.
Note Save the screws for reassembly.
2. Pull the power supply down and away from the stand.
Reassembly notes
Kit item:
• 7000-PS, Connex Spot 35 Watt Power Supply
Note Reassembly is the reverse of disassembly, but you need to thread the
power cable through one of the spaces next to the pole to reach the
monitor.
Service manual Disassembly and repair 83
To Next Page
Loading...
