Welch Allyn Connex Spot Monitor - Attach the APM Work Surface to the Stand

Attach the APM work surface to the stand
1. Take the 4 screws used to attach the APM work surface to the stand and partially
screw them into the APM work surface with your fingers. Do not tighten.
2. Lower the screws into the stand bracket keyholes.
3. Slide the APM work surface backward on the stand bracket.
4. Tighten the 4 screws using a 3mm hex key.
5. Insert the battery.
Remove the APM work surface battery
Before removing the APM work surface battery, power down the monitor and
disconnect the power cord from the wall.
Note You do not have to remove the APM work surface from the stand to
remove the APM work surface battery.
80
Disassembly and repair Connex
®
Spot Monitor