Reassembly notes
Kit items:
• 105939, End cap
• 105923, Back housing (includes battery, speaker foam, 6 screws, and labels)
Note The back housing is not available for direct purchase. Welch Allyn limits
availability of certain parts to Authorized Service Personnel only. These
limitations are required to maintain product safety or maintain current
regulations.
Note Reassembly is the reverse of disassembly.
Remove the temperature module or housing
The monitor is configured with either a SureTemp or Braun ThermoScan
PRO 6000 temperature module. Proceed witih the disassembly steps that
apply to your device.
Remove the SureTemp module
1. Disconnect the ribbon cable by lifting the connector.
54
Disassembly and repair Connex
®
Spot Monitor
To Next Page
Loading...
