Welch Allyn Connex Spot Monitor - Data Management; General Alarms

Settings Default value
4.
Scroll down to Other on the General Device Settings page and select the desired Power Line Frequency.
5.
Click DONE at the bottom of the page.
6.
Click SAVE AND CONTINUE.
Data management
Settings Default value
Date format MM/DD/YYYY
Prevent date and time changes No
Display date and time Yes
Daylight savings time (DST) enabled No
Device time zone offset (minutes) 0
Configured language English
Office profile option enabled Yes
Intervals profile option enabled Yes
Spot Check profile option enabled Yes
Profile Spot Check
Automatically send confirmed readings on Save No
Delete confirmed readings after successful send No
Automatically send uncomfirmed interval readings No
General alarms
Settings Default value
Alarm volume Medium
Audio pause time 120 seconds
Minimum alarm volume Low
Alarm condition priority to activate Nurse call Medium
Allow global audio off (Note: Must be enabled in configuration file for
option to be available,)
No
Service manual Appendix 139