2-9
COMPLETE INSTALLATION
1. Check the electrical requirements. Be
sure that you have the correct electrical
supply and the recommended grounding
method. See “Electrical Requirements,”
page 2-5.
2. Check to be sure all parts are now in-
stalled. If there is an extra part, go back
through the steps to see which step was
skipped.
3. Check that you have all of your tools.
4. Dispose of or recycle all packaging mate-
rials.
5. Check that the water faucets are on.
6. Check for leaks around faucets and inlet
hoses.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, fire, or electrical shock.
Use only HE High Efficiency detergent.
7. Plug into a grounded 3 prong outlet.
8. Read “Washer Use,” page 3-2.
9. To test and to clean your washer, use
1/2 the manufacturer’s recommended
amount of detergent for a medium sized
load. Pour the detergent into the deter-
gent dispenser. Select NORMAL/CA-
SUAL, and then select START. Allow the
washer to complete one whole cycle.
To Next Page