Whirlpool WFC7500VW0 - Removing the Water Inlet Valve

4-4
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Unplug washer or disconnect power.
2. Turn off the water supply to the washer.
3. Remove the water hoses from the hot
and cold water inlet valve.
4. Remove the top cover (see page 4-2 for
the procedure).
WARNING
REMOVING THE WATER INLET VALVE
Water Inlet Valve
5. Depress the locking tabs (see the top
right photo), and pull the wire connec-
tors out of the hot and cold/bleach water
inlet valve solenoid terminal holders.
Loosen the clamp, and pull the water in-
let hose off the water inlet valves.
7. At the rear of the washer, remove the
screws from the water inlet valve. Rotate
the valve to the right, and push it into the
washer off the rear panel.
Depress Locking Tab
Solenoid
Terminal
Holder
Hot Water
Inlet
Valve
Cold /Bleach Inlet Valve
Water Inlet Valve Screws
Water Inlet Valve Screws