Whirlpool WFC7500VW0 - Error Codes; Noisy, Vibrating, Off-Balance

3-14
TROUBLESHOOTING
WASHER & COMPONENTS
ERROR CODES
An error code may be shown in the Estimated
Remaining display. Check the list below
for potential problem and troubleshooting
checks.
“A09” on display (Water Inlet Problem—no •
water or insufcient water supply)
Check the following:
Are water faucets completely turned on?
Are screens at inlet hose connection to
washer clogged? Are water inlet hoses
kinked?
Are water inlet hoses frozen?
Plug in washer or reconnect power. Press
and hold START to continue the cycle or
press and hold CANCEL/DRAIN to cancel
the cycle. If the problem remains, call for
service.
“A10” on display (Drain Problem)•
Unplug washer or disconnect power.
Check the following:
Is the drain hose kinked?
Is the drain hose frozen?
Is the drain hose clogged?
Is the drain hose more than 55" (1.4 m) above
the oor?
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, re, or electrical shock.
WARNING
NOISY, VIBRATING, OFF-BALANCE
Is the washer level?•
The washer must be level. The four feet
should be properly installed, and the nuts
should be tightened against the washer
cabinet.
All four feet of the washer must be in rm
contact with the oor. If the washer is on a
pedestal, the washer must be secured to the
pedestal and all four pedestal feet must be
in rm contact with the oor.
Washer making a different noise?•
As with any new product, you will hear sounds
that you are not accustomed to. You may hear
various sounds when the door is locked or
unlocked, and during the washing, rinsing, or
spinning process. Between changes in wash
actions, there will be momentary pauses.
You will hear water spraying and splashing
during the wash and rinse cycles. These
new sounds and pauses are part of normal
washer operation.
Is washer installed on a sturdy and solid •
oor?
Refer to the “Installation Instructions” for oor-
ing requirements. Noise and vibration may
be reduced by placing a piece of 3/4˝ (19.1
mm) plywood underneath your washer.
The plywood may extend underneath both
washer and dryer to keep them at equal
heights.
Is the washer gurgling or humming?•
As water is drained from the washer, you
may hear air being pulled through the pump.
This happens during the end of draining. It
is normal.
Are you washing items with metal snaps, •
buckles or zippers?
You may hear metal items touching the
“F” Variables [F01 - F30] (Electrical Prob-
lem)
Switch knob or press and hold START to
cancel the cycle.
Select DRAIN/SPIN if there is excessive
water in the washer.
Re-select cycle and press START. If the
problem remains, call for service.