Operation
0620−1/A1
Winterthur Gas & Diesel Ltd.
3/ 3
2.2 Procedure Intervals
WARNING
Injury Hazard: Before you operate the turning gear, make sure
that no personnel are near the flywheel.
Do steps 1) to 12) below each week:
1) Make sure that the indicator valves are open.
2) Use the turning gear to turn the engine until the piston is at 60_ before or after
TDC (look on the flywheel). Cylinder lubricating oil can then flow directly into the
piston ring pack.
3) In the field MANUAL LUBRICATION ON CYL. in the operator interface, select the
related cylinder number.
Note: The lubricating oil pump and the servo oil service pump must operate
(see 0140−1 Prepare the Cylinder Lubricating System).
4) Use the turning gear to turn the engine two full turns to apply the cylinder
lubricating oil to the cylinder liner wall.
5) The recommended intervals are:
a) Weekly in dry climates
b) Daily in damp climates.
6) Stop the engine each time in a different position.
7) Open the cover on the rail unit and look for signs of condensation and corrosion.
8) Remove the inspection cover from supply unit and look for signs of condensation
and corrosion on the internal housing, camshaft, cams and roller.
9) If there are signs of corrosion, carefully clean the applicable parts.
10) Apply an anti-corrosion oil to give protection.
11) Decrease the lubrication intervals.
12) Apply oil as a spray to the dry parts.
3. Condition Two
If the engine must stop for a long period, it must be thoroughly cleaned and preserved
on the inside and the outside (ask for the preserving instructions from Winterthur Gas
& Diesel Ltd.).
Prepare the Engine for a Long Shutdown Period
2017−08
To Next Page
Loading...
Need help?
General
