Maintenance
2303−1/A1
RT-flex58T-D
Winterthur Gas & Diesel Ltd.
5/ 7
⇒ After assembly of the ring supports for grooves ’d’ − ’i’ (Fig. ’D’), place two dis-
tance pieces 94345F (19 mm) on the uppermost ring support 5 and fit sealing
rings 3, 4 and tension spring 8 for groove ’c’.
D Take care that one segment is always provided with two horizontal locating
pins 7a lying side by side on sealing ring 4. These locating pins must fit into the
corresponding bores in sealing ring 3. Remove possibly existing vertical locat-
ing pins 7.
The remaining three segments are provided only with one horizontal locating
pin each.
⇒ Place distance pieces 94345F (19 mm) on the assembled sealing ring 3 and fit
again sealing rings 3, 4 and scraper ring 2 with tension springs 8 for groove ’b’.
D Proceed in the same way as mentioned above for sealing rings 3 and 4, how-
ever, a vertical locating pin 7 in sealing ring 3 must fit into the respective recess
in scraper ring 2.
No vertical locating pin may be fitted in the scraper ring.
⇒ Place distance pieces 94345F (11 mm) on the assembled scraper ring 2 and
fit the two uppermost scraper rings 2 with their tension springs 8 for groove ’a’.
No vertical locating pin may be fitted in the uppermost scraper ring.
D
2
3
4
5
6
6
3
4
2
012.153/044
GROOVE a
GROOVE b
GROOVE c
GROOVES d−i
7
9
17
8
7
1
1
7a
7a
006.097/99
2013
Piston Rod Gland: Dismantling and Assembling, Measuring the Wear
To Next Page
Loading...
