Maintenance
3303−4/A1
RT-flex58T-D
Winterthur Gas & Diesel Ltd.
3/ 7
2. Removal
D Loosen and remove the nuts of the top end bearing according to 3303−1.
⇒ Connect manual ratchets ’H1’ to RUD-eye bolts ’RC1’ in cylinder block 10 and
guide shoe middle part 8.
⇒ Tighten RUD-eye bolts ’RC2’ to connecting rod 2 with 330 Nm.
⇒ By means of shackles 94572C fasten manual ratchets ’H2’ & ’H2a’ between
connecting rod and suspension centers ’a’ and ’b’ on the column and lock the
connecting rod into position.
⇒ Using manual ratchets ’H1’ hoist crosshead 6 until retaining pins 94323 can
be inserted into guide ways 9.
⇒ Carefully lower the crosshead until the guide shoes come to rest on the retain-
ing pins (if, however, not all retaining pins touch the guide shoes, turn them
such that their eccentrics contact the guide shoes).
Risk of accident! For safety reasons do not remove manual ratchets ’H1’!
WCH00390
B
a
b
H2
RC2
I
I
I - I
H1
RC1
RC2
2
H2a
RC2
6
94323
9
94323
94572C
94572C
5
RC1
V2 / 2013
Removal and Fitting
To Next Page
Loading...
