Maintenance
3303−5/A1
RT-flex58T-D
Winterthur Gas & Diesel Ltd.
3/ 3
⇒ Fasten manual ratchet ’H2’ with round sling 94049A to the column.
⇒ Remove bearing cover 5 from the crankcase using manual ratchets ’H2’ and
’H3’.
2. Fitting
Fitting of the bearing cover is carried out analogously to the removal but in reverse
sequence.
D The running surfaces have to be lavishly smeared with clean bearing oil.
D Tensioning of the elastic studs must be carried out according to 3403−1.
Attention! Always fit toggle lever 4 in such a way that its curvature stands up-
wards.
D
WCH01032
H2
H3
5
GF 94333D
H1
RC, 94049
94049A
Removal of Bearing Cover to Top End Bearing
V2 / 2013
To Next Page
Loading...
