103
ENGLISH
9. Plug & Play for the handset (option)
It is possible using the plug & play option to relocate the handset quickly and conveniently
from one side of the bed to the other side:
▪ Unplug the power plug of the bed from the mains power outlet
▪ If the handset should be moved from the left to the right side, unplug the the multi-pin con-
nector from the left connection and seal the socket with the attached plug.
▪ Connect the connector to the right connection after the plug has been removed from the
socket.
▪ The buttons of the handset are illuminated when the bed is connected to the power supply.
10. Handling the power cable correctly
The sentida low nursing bed is equipped with a coiled cable with a plastic hook attached to it.
▪ If you want to move the sentida low nursing bed,
hang the power cable hook on the top edge of the
head section. This prevents running over the cable
accidentally.
▪ Regularly check the mains power supply connection
cable, the correct insertion of the power plug, the
power plug case and the case inlets on the bed for
damage to rule out hazards.
When moving the bed, make absolutely sure not to drag the power cable across
the oor, squash it or run over it with the bed castors. Also keep this in mind when
operating/adjusting the bed. The cable must be able to follow each of the bed's
movements freely. Put any excess length of cable on the plastic hook in a gure-of-
eight loop.
Do not touch the power cable with wet hands and always hold the plug when pulling
it out of the socket.
To Next Page
Loading...
