106
ENGLISH
11.4 Moving and braking (sentida 6, 6-le, 6-xs, 6-s, 6-m, 6-xl, 6-d)
To activate the brake bar, move the bed into the bed egress position or higher. The brake bar
can now be activated with the foot in three positions.
When moving the bed, please adhere to the following steps:
▪ Release the brakes.
▪ At its head or foot end, move the bed to the desired position.
▪ Then, activate the castors again by pushing the brake bar.
03
01
02
11.5 Mechanically adjusting calf section
The height of the calf section can be adjusted by using ratchets.
▪ If you want to raise the calf section manually, hold it at the mattress restricting bars (see
arrows) and lift it.
It clicks into the desired position.
▪ If you want to lower the calf section manually, hold it at the mattress restricting bars, lift it as
high as possible and then lower it.
Ensure that both sides of the calf rest are pulled as far as the stop.
Position 01: Brake
Position 02: Can be moved
Position 03: Direction locking
(In this case, the tilting movement of the left
castor at the head end is blocked, thereby
making it easier to maneuver the bed.)
To Next Page
