5.2 Common Menus Setting 125
[USB-2 (2.0)]
Adobe Protocol Sets the PostScript communication protocol.
• [Normal] (default)
Select this when the communication protocol is in ASCII format.
•[Binary]
Select this when no special processing is required for data. Some data is
printed slower than with the [Normal] protocol.
•[TBCP]
Select this when the communication protocol is both in the ASCII and binary
formats, and switches between the two using control codes.
•[RAW]
Select this when the communication protocol is in Raw format. Select this
item when EPS files cannot be printed properly from Macintosh computers
on the USB interface.
Note
• Select an appropriate option according to the data format specified on your
print driver.
• [Adobe Protocol] is enabled only when printing in PostScript.
• Normally, use this setting at its default [Normal].
Network/Port
USB-2 (2.0)
USB-2 (2.0)
Port Status
USB-2 (2.0)
Print Mode
USB-2 (2.0)
PJL
USB-2 (2.0)
Auto Eject Time
USB-2 (2.0)
Adobe Protocol
Setting Description
Port Status Sets whether to enable or disable the USB port at printer start-up.
• [Enabled] (default)
• [Disabled]
Important
• When there is not enough memory, either disable unused ports, or change
the memory allocation under [Allocate Memory].
Setting Description
To Next Page
Loading...
