126 5 Control Panel Settings
Print Mode Sets the method of processing data (language emulation).
• [Auto] (default)
After receiving data from a computer, the printer automatically detects its
language emulation and processes the data accordingly. *1 (See P. 171.)
• [PS] [ESCP] [HP-GL/2] [PCL] [TIFF] [KS] [KSSM] [KS5895]
After receiving data from a computer, the printer processes the data with the
selected print language.
• [HexDump]
Allows you to view data received from a computer by printing it in ASCII code
(hexadecimal format). *3 (See P. 171.)
Note
• [KS], [KSSM], and [KS5895] appear when the Korea Font ROM (optional) is
installed.
PJL Sets whether to enable or disable PJL commands that are sent from the
computer.
PJL commands control print jobs, and are required to print jobs using the print
driver. Use of PJL commands allows you to specify the language emulation for
the next job while another language emulation is being processed by the
printer. *5 (See P. 171.)
• [Enabled] (default)
• [Disabled]
Auto Eject Time Sets the time that data still remaining on your printer is automatically printed
and ejected when data has continuously not been received.
Set the time with the range 5 to 1275 seconds in 5-second increments. *2 (See
P. 171.) Jobs are judged as finished when the next data is not received within
the time set here, after the last data has been received.
• [30 Seconds] (default)
Adobe Protocol Sets the PostScript communication protocol.
• [Normal] (default)
Select this when the communication protocol is in ASCII format.
•[Binary]
Select this when no special processing is required for data. Some data is
printed slower than with the [Normal] protocol.
•[TBCP]
Select this when the communication protocol is both in the ASCII and binary
formats, and switches between the two using control codes.
•[RAW]
Select this when the communication protocol is in Raw format. Select this
item when EPS files cannot be printed properly from Macintosh computers
using a USB interface.
Note
• Select an appropriate option according to the data format specified on your
print driver.
• [Adobe Protocol] is enabled only when printing in PostScript.
• Normally, use this setting at its default [Normal].
Setting Description
To Next Page
Loading...
Need help?
General