4.2 Loading Paper 97
Bypass Tray Feed Orientations for Envelopes
Make sure to use the proper orientation whenever loading envelopes into the bypass tray.
Important
• For best print quality, do not use envelopes that:
• are curled or twisted.
• are stuck together or damaged.
• have windows, holes, perforations, cutouts, or embossments.
• use tie strings, metal clamps, or metal folding bars.
• have postage stamps attached.
• have any exposed adhesive when the flaps are closed.
• have deckle edges or creased corners.
• are wrinkled, rough or are glued.
• have adhesive flaps.
• In cases where you must print on envelopes with adhesive flaps, close the flaps and load the envelopes
so they feed from the flap side. Loading envelopes with adhesive flaps open can cause a malfunction.
Envelopes
With the address side face down, open the flaps
of the envelopes and position them so they feed
from the side opposite the flap (from the bottom of
the envelopes). Make sure that the flaps are fully
open.
To Next Page
Loading...
Need help?
General