Xerox FreeFlow

FreeFlow Process Manager Operator and Administrator Guide
2-143
Workflow Builder
6. After the job passes successfully through the Imposition node,
the user opens the Copy Count dialog at the second Review.
They see:
• Quantity (original document): 20
• Quantity (imposed document): 10
7. At the second Review the user looks at the Print task setting.
They see: Quantity: 10
8. The job prints 10 actual copies of the imposed document.
Example 4: Original quantity is 20 with 2-up + 2-up;
quantity modifed after first Imposition; actual copies = 6
1. The user sets the Copy Count Divisor switch to On.
2. User creates a workflow with the following nodes:
• Imposition (2up; Always use these settings is set)
•Review
• Imposition (2up; Always use these settings is set)
•Review
•Print (Always use these settings is not set)
3. User submits a job with an XPIF ticket: Copies=20
4. After successful execution of the first Imposition, at the first
Review, the user opens the Copy Count Dialog. The user
sees:
• Quantity (original document): 20
• Quantity (imposed document): 10
5. The User modifies the Quantity (imposed document) value in
the Copy Count Dialog to 12:
• Quantity (original document): 20
• Quantity (imposed document): 12
6. After successful execution of the second Imposition, at the
second Review, the user opens the Copy Count Dialog. They
see: Quantity (original document): 20
7. Quantity (imposed document): 6. Since the user modified this
value at the first Review, the second Imposition node takes the
modified value and applies the copy count divisor logic.
8. The job prints 6 actual copies of the imposed document.