Environmental Benefits of Duplex Printing
Most Xerox products have duplex printing, also known as 2-sided printing, capability. This enables you
to print on both sides of the paper automatically, and therefore helps to reduce the use of valuable
resources by reducing your paper consumption. The Lot 4 Imaging Equipment agreement requires that
on models greater than or equal to 40 ppm color or greater than or equal to 45 ppm monochrome the
duplex function has been auto-enabled, during the setup and driver installation. Some Xerox models
below these speed bands may also be enabled with 2-sided printing settings defaulted on at the time
of install. Continuing to use the duplex function will reduce the environmental impact of your work.
However, should you require simplex/1-sided printing, you may change the print settings in the print
driver.
Paper Types
This product can be used to print on both recycled and virgin paper, approved to an environmental
stewardship scheme, which complies with EN12281 or a similar quality standard. Lighter weight paper
(60 g/m²), which contains less raw material and thus saves resources per print, may be used in certain
applications. We encourage you to check if this is suitable for your printing needs.
Regulatory Information for 2.4-GHz and 5-GHz Wireless Network Adapter
This product contains a 2.4-GHz and 5-GHz Wireless LAN radio transmitter module that complies with
the requirements specified in FCC Part 15, Industry Canada RSS-210, and European Council Directive
2014/53/EU. Radio Frequency (RF) output power of this device will not exceed 20 dBm in either frequency
band.
Operation of this device is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications to this device not specifically approved by the Xerox Corporation may void
the user's authority to operate this equipment.
United States FCC Regulations
This equipment has been testedand found to comply with the limits for a Class A digital device, pursuant
to Part 15 and Part 18 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy. If the equipment is not installed
and used in accordance with these instructions, it can cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful interference. Users are required
to correct the interference at their own expense.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
B-3Xerox
®
VersaLink
®
B605/B615 Multifunction Printer
User Guide
Regulatory Information
To Next Page
Loading...
Need help?
General
Weight and Dimensions
