Xerox WorkCentre 5945

Administration and Accounting WorkCentre
®
5945/5955
676 User Guide
Perform a Software Reset
You can use the Tools menu to adjust the brightness of the Control Panel display, change the billing
impression mode, perform a software reset or enable optional features on your device.
Note: This option must be made available by your System Administrator.
Use Software Reset if you need to reboot the device. A software reset does not turn the device off
and is faster and wastes fewer consumables than turning the power off and then on.
Refer to the System Administrator Guide for further information.
1. Press the Machine Status button on the Control Panel.
2. Select the Tools tab on the touch screen.
3. Select the Troubleshooting button.
4. Select the Resets button.
5. Select the Software Reset button.
6. Select the required option:
• All Software resets the network and copy system software.
• Network Software resets the network controller software.
• Copy Software resets the copy system software.
7. Select the Reset button.
8. Select the Close button.
More Information
System Administrator Guide www.xerox.com/support.
Using Internet Services to find System Administrator Contact Details