-.-H
__
- Free play
1.5"'2.5
mm
(0.06"'0.10
in)
1.
Adjuster
2. Lock
nut
1. Play
2.
Adjusting
screw
3. Lock
nut
Free play between
outer
tube
end
and
adjuster:
1.5'"
2.5 mm
(0.06'"
0.10 in)
3. Lock
the
adjusting screw by tightening
the
nut.
C.
Throttle
Cable
Adjustment
Set
the
throttle
cable adjuster so
that
the
free
play between
the
throttle
cable
outer
tube
end and adjuster equals specification when
the
throttle
valve is closed (at idle).
Free play between
outer
tube
end
and adjuster:
0.5'"
1.0 mm (0.2 '" 0.4 in)
E. Low Speed Tuning
The
carburetor
is built so
that
low speed
tuning can be
done
by adjusting
the
slow
adjuster and
the
throttle
stop
screw.
Always install air silencer before making
tuning adjustment. High performance
tuning
cannot
be done
without
the
silencer. Engine
damage may result
from
attempting
to
tune
without
the
silencer installed.
Play:
25 ± 1 mm (1.00 ± 0.04 in)
NOTE: _
Always adjust
the
throttle
cable BEFOR E
adjusting
the
oil
pump
cable.
2.
Start
the
engine,
and
fully warm up
the
engine.
3. Adjust
the
throttle
stop
screw until
the
engine runs at
2,000'"
2,500 rpm.
Stardard
pilot screw
(turns
out):
1-1/4
1. Tighten
the
slow
adjuster
lightly,
and
back it
out
from its lightly seated posi-
tion.
1.
Slow
adjuster
3. Play
2.
Lock
nut
1. Loosen
the
lock
nut
on
the
oil
pump
cable adjusting screw.
2. Pull up
the
cable
to
its limit, and
turn
the
adjusting screw until
the
free play of
the
outer
cable is as specified below:
1.
Adjuster
D. Oil
Pump
Cable
Adjustment
3-5
To Next Page
Loading...
